Pre order - USD16.99

 

This device is capable of use without decreasing

the servo performance, it accents the

resolution and smoothness especially on

Giant scale Airplanes, and excessive hunting

can be reduced.Be sure to apply JR “Super

Grease” in between the moving surface of

servo arm and around the servooutput shaft

area on top servo case. (Note: It is suggested

to use the “Poly Slider” plastic washer between

the dampener with Super Grease applied

on both sides)

【 Warning】

Having too many dampener plates can cause

too much friction causing high current

draw and damage to the servo. Be sure to

check that servo movement is not too tight

when dampener plate is installed.

Also note that the gap between the servo

arm and around the servo output shaft area

on top of the servo case may differ depending

on the type of servo arm installed. Be

sure that there is enough gap between the

servo case and servo arm to install this dampener

plate.

■It is suggested to use an amp meter to check the amperage while the servo is without the control surface load (disconnect the linkage to the control surface). Current should be within 0.1A to 0.2A as maximum current comparison of not having dampener plate.

■Be sure to check that servo movement is not too heavy load by having dampener plate installed. Also note that gap between the Servo arm and around the servo output shaft area on top servo case may be different depend on the installation of the arm or the type of Servo manufacturer. Be sure that there is an enough gap between to install this dampener plate.

 

Servo Damper kit Black(0.5mm/4set)

RM69.66Price
  •